Left Banner

  • LeftBanner 1

Megane II (02-10)

Renault Megane 2 | Tuning Accessories and LED Lights | QSPCARS

Active Filters

  • Function: Light Transformation
  • Color: 6.500K Ice White Light
H7 LED Kit for Renault MEGANE 2 Low Beam CANbus Bulbs | 6500K...
COMPATIBILITY:

- For Lowbeam RENAULT MEGANE 2 (2002-2010)


FOR AN OPTIMUM MOUNTING, WE RECOMMEND:

- DISMOUNTING YOUR HALOGEN BULBS

- CHECK FIRST: Connect only the led socket (PLUG AND PLAY ); if there is not any problem, proceed with mounting operations.

- BLOCK ONLY THE LED RING: Remove the led ring from the led bulb using circular motion and fix in the locking clip of the halogen bulb.

- IMPORTANT: THE LIFE OF THE LED DEPENDS ON THE HEATSINK: Open the copper heatsink as much as possible, till you obtain a "rose shape" heatsink. Extend each heatsink, don' t be afraid to use force.

- CONNECT THE SOCKET AND LOCK THE BULB: Put the bulb inside its ring that you had previously fixed, and lock it using circular motion.




NON-STANDARD CASES


- DEEPER DUST CAPS:

Being a TRANSFORMATION kit, and not replacement bulbs, it has bigger dimensions.
If the installation of the kit does not allow to close the headlight anymore, visit our store for DEEPER DUST CAPS.

- ADAPTERS:

All cars that do not have the STANDARD LOCKING CLIP to lock the halogen bulb, may need simple ADAPTERS; found them in OUR STORE.
IMPORTANT: Their compatibility could not always depend on the model of your car; it depends mainly on the LOCKING SYSTEM of the halogen bulbs of your headlight.
€61.88 Regular Price €64.46
License Plate Light Full LED for Renault Megane 2 18 Leds 6500K Ice White | Canbus Plug & Play
  • -3%
  • Out of Stock
License Plate Light Full LED for Renault Megane 2 18 Leds...
COMPATIBILITY:

RENAULT:

- Renault Megane 2 (2002-2010)




GENUINE PART NUMBER:26510-00Q0A;265108474R;4159062300;4416659;4422473;8200480127;93188920;93450297;A4159062300



INSTRUCTION:

- Remove the current led plates, using a screwdriver if necessary, inserting the tip in the side part of the plate and apply pressure towards the outside: the plate will come out./ If Screws present Remove them by unscrewing them to release the plate

- Disconnect the cable and disconnect definitely the plate.

- Connect the new LED PLATE to the cable and replace it inside the housing. Repeat the same operation with the second plate.


FOR AN OPTIMAL MOUNTING, WE ALWAYS RECOMMENDS THE INSTALLATION BY AN EXPERT


We do not take responsibility for: erroneous purchases - violations of regulations or laws of any state - damages, which you may cause to you, to third parties or to the same article, as we describe each individual specification in detail. WE WILL NOT ACCEPT RETURNS FOR INCOMPATIBILITY or WRONG PURCHASES
€20.94 Regular Price €21.59