Model 3 (from 2016)

Tesla Model 3 | Tuning Accessories and LED Lights | QSPCARS

Active Filters

  • Use on: Rear Trunk - Roof
Rear SPOILER for TESLA MODEL 3, Aerodynamic Trunk Boot Spoiler...
COMPATIBILITY:

- For Tesla Model 3 (from 2016)


ASEMBLY:

ATTENTION: Although double-sided adhesive tape is supplied, for a perfect hold, it is recommended to glue the spoiler to the bodywork with appropriate professional mastics.

- Thoroughly wash and clean the surface to which the spoiler is to be applied.
- Adhere the spoiler to the desired part with bodywork mastics
- Use a bodywork dryer to finish fixing
- Do not expose to humidity for 32h




FOR OPTIMAL MOUNTING, EVEN IF SIMPLE REPLACEMENT, WE ALWAYS RECOMMEND THE INSTALLATION OF AN EXPERT, as we do not assume responsibility for articles mounted and subsequently detached. We trust in your common sense.
€141.53 Regular Price €148.98
Rear Adhesive LED SPOILER For Tesla Model 3 | Roof SEQUENTIAL...
COMPATIBILITY:

- Specific for Tesla Model 3


ASSEMBLY:

- Wash and thoroughly clean the surface where the spoiler is to be applied

- Remove the 3M adhesive film, and adhere the spoiler to the desired part

- Connect the 3 Wires, Respectively:

BLACK: Connect to Neutral Ground
RED: Connect to the Base Lighting System
WHITE: Connect to the STOP light switch-on function

(For a perfect fixing, use a bodywork thermal hair dryer)

It is possible to cut and then shorten the spoiler from the side where the wire is not present, but this modification will inevitably involve the decentralization of the Dynamic LED function.





FOR OPTIMAL MOUNTING, EVEN IF SIMPLE REPLACEMENT, WE ALWAYS RECOMMEND THE INSTALLATION OF AN EXPERT, as we do not assume responsibility for articles mounted and subsequently detached. We trust in your common sense.

€53.17 Regular Price €55.97
Rear Adhesive LED SPOILER For Tesla Model 3 | Roof LED Strip in Translucent Black
  • -5%
  • Out of Stock
Rear Adhesive LED SPOILER For Tesla Model 3 | Roof LED Strip...
COMPATIBILITY:

- Specific for Tesla Model 3


ASSEMBLY:

- Wash and thoroughly clean the surface where the spoiler is to be applied

- Remove the 3M adhesive film, and adhere the spoiler to the desired part

- Connect the 3 Wires, Respectively:

BLACK: Connect to Neutral Ground
RED: Connect to the Base Lighting System
WHITE: Connect to the STOP light switch-on function

(For a perfect fixing, use a bodywork thermal hair dryer)

For a perfect fit, it is possible to cut and then shorten the spoiler from the side where there is no clable; but, ATTENTION, once the modification has taken place, the Warranty and Right of Return will expire.





FOR OPTIMAL MOUNTING, EVEN IF SIMPLE REPLACEMENT, WE ALWAYS RECOMMEND THE INSTALLATION OF AN EXPERT, as we do not assume responsibility for articles mounted and subsequently detached. We trust in your common sense.

€47.47 Regular Price €49.97