Italiano
Inglese
Francese
Tedesco
Spagnolo
- -5%
- New
Car Roof Carbon Fiber Effect SHARK FIN Universal Antenna |...
COMPATIBILITY REQUIREMENTS:
1) Screw-on Antenna
2) MAXIMUM Antenna Base Dimensions: CM 10 X CM 6 X H CM 5, (To be housed inside the new Antenna Body)
CAUTION:
- Analyze the position of your current antenna on the car roof: make sure that the antenna does not protrude either on the windscreen or on the rear of the car.
ASSEMBLY INSTRUCTIONS:
- Unscrew the current screw-on antenna
- Clean and wash the surface of the car carefully and thoroughly
- Apply the double-sided adhesive film to the underside of the antenna
- Screw the cable of the Shark Fin antenna using the two bolts supplied, where the classic Antenna was positioned.
- Remove the film and attach the new shark fin antenna to the roof of the car, applying the right pressure to make the adhesive adhere.
- For a perfect fixing, use a thermal body dryer.
ATTENTION
Although the installation is simple and intuitive, and the quality of the adhesiv film, we ALWAYS RECOMMEND THE INSTALLATION BY AN EXPERT.
Storage times or even simple humidity, could compromise a little the installation. For the perfect anchorage, we always recommend replacing the double-sided tape with a new one for maximum durability.
We do not take responsibility for: erroneous purchases - violations of regulations or laws of any state - damages, which you may cause to you, to third parties or to the same article, as we describe each individual specification in detail. WE WILL NOT ACCEPT RETURNS FOR INCOMPATIBILITY or WRONG PURCHASES
1) Screw-on Antenna
2) MAXIMUM Antenna Base Dimensions: CM 10 X CM 6 X H CM 5, (To be housed inside the new Antenna Body)
CAUTION:
- Analyze the position of your current antenna on the car roof: make sure that the antenna does not protrude either on the windscreen or on the rear of the car.
ASSEMBLY INSTRUCTIONS:
- Unscrew the current screw-on antenna
- Clean and wash the surface of the car carefully and thoroughly
- Apply the double-sided adhesive film to the underside of the antenna
- Screw the cable of the Shark Fin antenna using the two bolts supplied, where the classic Antenna was positioned.
- Remove the film and attach the new shark fin antenna to the roof of the car, applying the right pressure to make the adhesive adhere.
- For a perfect fixing, use a thermal body dryer.
ATTENTION
Although the installation is simple and intuitive, and the quality of the adhesiv film, we ALWAYS RECOMMEND THE INSTALLATION BY AN EXPERT.
Storage times or even simple humidity, could compromise a little the installation. For the perfect anchorage, we always recommend replacing the double-sided tape with a new one for maximum durability.
We do not take responsibility for: erroneous purchases - violations of regulations or laws of any state - damages, which you may cause to you, to third parties or to the same article, as we describe each individual specification in detail. WE WILL NOT ACCEPT RETURNS FOR INCOMPATIBILITY or WRONG PURCHASES
€18.02
Regular Price
€18.97
