166 (98-03)

Alfa 166 98-03 | Tuning Accessories and Xenon LED Lights | QSPCARS

Active Filters

  • Category: LIGHTING
H7 LED Kit for Alfa Romeo 166 Low Beam CANbus Bulbs | 6500K...
COMPATIBILITY:

- For Alfa Romeo 166 (1998-2003), Lowbeam



FOR AN OPTIMUM MOUNTING, WE RECOMMEND:

- DISMOUNTING YOUR HALOGEN BULBS

- CHECK FIRST: Connect only the led socket (PLUG AND PLAY ); if there is not any problem, proceed with mounting operations.

- BLOCK ONLY THE LED RING: Remove the led ring from the led bulb using circular motion and fix in the locking clip of the halogen bulb.

- IMPORTANT: THE LIFE OF THE LED DEPENDS ON THE HEATSINK: Open the copper heatsink as much as possible, till you obtain a "rose shape" heatsink. Extend each heatsink, don' t be afraid to use force.

- CONNECT THE SOCKET AND LOCK THE BULB: Put the bulb inside its ring that you had previously fixed, and lock it using circular motion.




NON-STANDARD CASES


- DEEPER DUST CAPS:

Being a TRANSFORMATION kit, and not replacement bulbs, it has bigger dimensions.
If the installation of the kit does not allow to close the headlight anymore, visit our store for DEEPER DUST CAPS.
€61.88 Regular Price €64.46
Rear Adhesive LED SPOILER For Alfa 166 | Roof SEQUENTIAL LED...
COMPATIBILITY:

- Specific for Alfa Romeo 166


ASSEMBLY:

- Wash and thoroughly clean the surface where the spoiler is to be applied

- Remove the 3M adhesive film, and adhere the spoiler to the desired part

- Connect the 3 Wires, Respectively:

BLACK: Connect to Neutral Ground
RED: Connect to the Base Lighting System
WHITE: Connect to the STOP light switch-on function

(For a perfect fixing, use a bodywork thermal hair dryer)

It is possible to cut and then shorten the spoiler from the side where the wire is not present, but this modification will inevitably involve the decentralization of the Dynamic LED function.





FOR OPTIMAL MOUNTING, EVEN IF SIMPLE REPLACEMENT, WE ALWAYS RECOMMEND THE INSTALLATION OF AN EXPERT, as we do not assume responsibility for articles mounted and subsequently detached. We trust in your common sense.

€53.17 Regular Price €55.97
Rear Adhesive LED SPOILER For Alfa 166 | Roof LED Strip in Translucent Black
  • -5%
  • New
  • Out of Stock
Rear Adhesive LED SPOILER For Alfa 166 | Roof LED Strip in...
COMPATIBILITY:

- Specific for Alfa Romeo 166


ASSEMBLY:

- Wash and thoroughly clean the surface where the spoiler is to be applied

- Remove the 3M adhesive film, and adhere the spoiler to the desired part

- Connect the 3 Wires, Respectively:

BLACK: Connect to Neutral Ground
RED: Connect to the Base Lighting System
WHITE: Connect to the STOP light switch-on function

(For a perfect fixing, use a bodywork thermal hair dryer)

For a perfect fit, it is possible to cut and then shorten the spoiler from the side where there is no clable; but, ATTENTION, once the modification has taken place, the Warranty and Right of Return will expire.





FOR OPTIMAL MOUNTING, EVEN IF SIMPLE REPLACEMENT, WE ALWAYS RECOMMEND THE INSTALLATION OF AN EXPERT, as we do not assume responsibility for articles mounted and subsequently detached. We trust in your common sense.

€47.47 Regular Price €49.97
2pcs LED REVERSE for Alfa Romeo 166 (98-07),  Bulbs P21W - BA15S With Lens 3D 21 Led, 6500K White ICE CANBUS
  • -3%
  • New
  • Out of Stock
2pcs LED REVERSE for Alfa Romeo 166 (98-07), Bulbs P21W -...
COMPATIBILITY:

- Alfa Romeo 166 (1998-2007), REVERSE Light



UNDERSTAND THE PURCHASE AND HOW TO CHOOSE THE BEST BULB:

THE DECEPTION OF BULBS WITH LOTS OF LEDS: The most common and BIGGEST PURCHASE MISTAKE happens in thinking that bulbs with more LEDs are better than those with less leds.

- The more the LEDs are on a plate / The shorter the distance between the LEDs is / the less they will last, since the greater the possibility that the LEDs will burn soon is, leading to malfunction, short-circuits, or lightning.

THE BAD ENEMY OF THE LED is the '' HEAT '', so if there are too many LEDs on a plate, or if they are too close, THE HEAT will cause the consequences described above

THIS TYPE OF BULBS USES THE AESTHETIC FACTOR OF SEEING LOTS OF LEDS AS A SHIELD OF USING A CHEAPEST AND LOW QUALITY PLATE

The greater the cooling area will be, the longer their DURABILITY and RELIABILITY will be
€22.29 Regular Price €22.98
2 License Plate FULL LED for Alfa Romeo 166 (98-07) | CANBUS...
COMPATIBILITY:

- ALFA ROMEO 166 (1998-2007)


INSTRUCTION:

- Remove the current led plates, using a screwdriver if necessary, inserting the tip in the side part of the plate and apply pressure towards the outside: the plate will come out.

- Disconnect the cable and disconnect definitely the plate.

- Connect the new LED PLATE to the cable and replace it inside the housing. Repeat the same operation with the second plate.


FOR AN OPTIMAL MOUNTING, WE ALWAYS RECOMMENDS THE INSTALLATION BY AN EXPERT


We do not take responsibility for: erroneous purchases - violations of regulations or laws of any state - damages, which you may cause to you, to third parties or to the same article, as we describe each individual specification in detail. WE WILL NOT ACCEPT RETURNS FOR INCOMPATIBILITY or WRONG PURCHASES
€20.78 Regular Price €21.65
2 LED Licence Plate Light for Alfa Romeo 166 (98-07), T10 W5W Bulbs 6500K Ice White, 100% CANBUS Error Free
  • -4%
  • New
  • Out of Stock
2 LED Licence Plate Light for Alfa Romeo 166 (98-07), T10 W5W...
COMPATIBILITY:

- Alfa Romeo 166 (1998-2007), LICENSE PLATE LIGHTS


UNDERSTAND THE PURCHASE AND HOW TO CHOOSE THE BEST BULB:

THE DECEPTION OF BULBS WITH LOTS OF LEDS: The most common and BIGGEST PURCHASE MISTAKE happens in thinking that bulbs with more LEDs are better than those with less leds.

- The more the LEDs are on a plate / The shorter the distance between the LEDs is / the less they will last, since the greater the possibility that the LEDs will burn soon is, leading to malfunction, short-circuits, or lightning.

THE BAD ENEMY OF THE LED is the '' HEAT '', so if there are too many LEDs on a plate, or if they are too close, THE HEAT will cause the consequences described above

THIS TYPE OF BULBS USES THE AESTHETIC FACTOR OF SEEING LOTS OF LEDS AS A SHIELD OF USING A CHEAPEST AND LOW QUALITY PLATE

The greater the cooling area will be, the longer their DURABILITY and RELIABILITY will be
€13.43 Regular Price €13.99
2 LED Licese Plate Light Bulbs for Alfa Romeo 166 (98-07), T10 W5W, White Light 6500K, 100% CANBUS Error Free
  • -4%
  • New
  • Out of Stock
2 LED Licese Plate Light Bulbs for Alfa Romeo 166 (98-07), T10...
COMPATIBILITY:

- Alfa Romeo 166 (1998-2007), LICENSE PLATE LIGHTS


UNDERSTAND THE PURCHASE AND HOW TO CHOOSE THE BEST BULB:

THE DECEPTION OF BULBS WITH LOTS OF LEDS: The most common and BIGGEST PURCHASE MISTAKE happens in thinking that bulbs with more LEDs are better than those with less leds.

- The more the LEDs are on a plate / The shorter the distance between the LEDs is / the less they will last, since the greater the possibility that the LEDs will burn soon is, leading to malfunction, short-circuits, or lightning.

THE BAD ENEMY OF THE LED is the '' HEAT '', so if there are too many LEDs on a plate, or if they are too close, THE HEAT will cause the consequences described above

THIS TYPE OF BULBS USES THE AESTHETIC FACTOR OF SEEING LOTS OF LEDS AS A SHIELD OF USING A CHEAPEST AND LOW QUALITY PLATE

The greater the cooling area will be, the longer their DURABILITY and RELIABILITY will be
€11.40 Regular Price €11.87