A1 8X Facelift (15-18)

Accessories and LED Lights for Audi A1 8X 15-18 Tuning | QSPCARS

Active Filters

  • Color: Metallic Silver
  • Color: Satin Grey

There Are 2 Products.

Sort by:
Sales, highest to lowest Relevance Name, A to Z Name, Z to A Price, low to high Price, high to low Reference, A to Z Reference, Z to A
Universal Car Roof BIKE RACK in Steel to be INSTALLED on Roof Bars | TÜV GS Approved
  • New
Add to Wishlist
Universal Car Roof BIKE RACK in Steel to be INSTALLED on Roof...
COMPATIBILITY:

- All Vehicles with Roof Bars


REQUIREMENTS:

- WHEEL WIDTH: from 25 mm to 35 mm
- BIKE FRAME DIAMETER: Ø from 28 mm to 40 mm
- ROOF BARS: Maximum 48 mm (Width) x 40 mm (Height)
- MAXIMUM LOAD WEIGHT: 15 Kg


INSTALLATION:

(Instructions Supplied)

- Secure the Frame Holder Pliers to each other, by means of the Special Spring + Bolt + Washer
- Attach the frame holder bracket to the front of the duct
- Screw the front part of the duct to the rear part
- Fix the Duct, complete with the Shelter Bracket, to the Car Roof Bars
- Secure the bike to the bike carrier by tightening the frame holder clamps and locking the wheels with the appropriate straps




Although simple and intuitive FOR AN OPTIMAL ASSEMBLY, WE ALWAYS RECOMMEND THE INSTALLATION OF OUR ITEMS BY AN EXPERT
As we will not take responsibility for the assembled and subsequently detached article.
We trust in your common sense.
Add to Wishlist
€39.98
Professional CROSS KEY Suitable for Audi Wheels | in Hardened STEEL | Bolts 17 - 19 - 21 - 23
  • -3%
  • New
Add to Wishlist
Professional CROSS KEY Suitable for Audi Wheels | in Hardened...
COMPATIBILITY:

- Wheels Vehicles, including Audi
- Nuts 17, 19, 21, 23

USE:

1) The bolts must be unscrewed before lifting the car, on a flat, stable and safe surface.
2) Insert the jack under the frame in the position indicated in the use and maintenance handbook.
3) Raise the jack just enough to tension it in the right position to support the car but without lifting it off the ground.
4) Remove the hubcap and loosen the nuts by turning the cross wrench counterclockwise.
5) The tire must be left in contact with the ground because in this way the force applied makes the nuts turn but not the wheel, which remains blocked by the ground.
6) The nuts must not be unscrewed completely but you must limit yourself to overcoming the resistance of the tightening.
7) Raise the car, completing the operation of unscrewing the bolts and removing the wheel which must be completed by hand.

The same operation must be done in reverse when refitting the replaced wheel, tightening the bolts last, to be carried out when the vehicle is already on the ground.
Add to Wishlist
€17.42 Regular Price €17.96