Italiano
Inglese
Francese
Tedesco
Spagnolo
- New
2 LED TAIL LIGHTS For Porsche Cayenne 2 (958) 10-14 APPROVED |...
COMPATIBILITY
- FOR Cayenne II (92A) 2010-2014
FOR OPTIMUM ASSEMBLY, WE ALWAYS RECOMMEND INSTALLATION BY AN EXPERT
- The headlight has the same connections as the original, therefore it will not be necessary to make changes to the wiring, the PLUG AND PLAY rule will apply (connection only).
ASSEMBLY:
- Open the trunk and take the key for removing the headlights from the spare wheel compartment.
- Open the front bonnet and remove with the pressure of a screwdriver the two plastic caps which have the Low Beam headlights emblem printed on them
- Pass the key taken previously through the hole, reaching the headlight release bolt.
- Rotate counterclockwise to release the original headlight
- PAY ATTENTION: (Forcing the release or attachment of the lighthouse could irremediably damage the lighthouse SLIDE)
- Remove the unhooked headlight and remove the electrical sockets
- Remove the 3 clips under the original headlight, unscrewing the 3 screws that block them (without them the new headlight cannot be anchored)
- Install the 3 clips on the new headlight
- Attach electrical sockets to the new lighthouse
- Insert the new headlight into the housing, bringing it to the end
- Lock the headlight by turning the key clockwise until it clicks
- Repeat the operation for the second Headlight
We do not assume responsibility for: incorrect purchases - violations of regulations or laws of each state - damage that could be caused to you, to third parties, to the Vehicle or to the item itself, as we describe every single specification in detail.
We also remind you that these are Aftermarket Items, designed for Full compatibility and operation on the designated vehicle, but they remain products that may not be permitted for use on public roads.
We trust in your common sense.
- FOR Cayenne II (92A) 2010-2014
FOR OPTIMUM ASSEMBLY, WE ALWAYS RECOMMEND INSTALLATION BY AN EXPERT
- The headlight has the same connections as the original, therefore it will not be necessary to make changes to the wiring, the PLUG AND PLAY rule will apply (connection only).
ASSEMBLY:
- Open the trunk and take the key for removing the headlights from the spare wheel compartment.
- Open the front bonnet and remove with the pressure of a screwdriver the two plastic caps which have the Low Beam headlights emblem printed on them
- Pass the key taken previously through the hole, reaching the headlight release bolt.
- Rotate counterclockwise to release the original headlight
- PAY ATTENTION: (Forcing the release or attachment of the lighthouse could irremediably damage the lighthouse SLIDE)
- Remove the unhooked headlight and remove the electrical sockets
- Remove the 3 clips under the original headlight, unscrewing the 3 screws that block them (without them the new headlight cannot be anchored)
- Install the 3 clips on the new headlight
- Attach electrical sockets to the new lighthouse
- Insert the new headlight into the housing, bringing it to the end
- Lock the headlight by turning the key clockwise until it clicks
- Repeat the operation for the second Headlight
We do not assume responsibility for: incorrect purchases - violations of regulations or laws of each state - damage that could be caused to you, to third parties, to the Vehicle or to the item itself, as we describe every single specification in detail.
We also remind you that these are Aftermarket Items, designed for Full compatibility and operation on the designated vehicle, but they remain products that may not be permitted for use on public roads.
We trust in your common sense.
€998.00
